Heating mat under the mirror - 70x70cm

Mission Air Self-Adhesive Mirror Heating Film 70cm x 70cm. This heating film eliminates the "fogged-up mirror" effect in the bathroom. In every bathroom, mirror surfaces often experience fogging when using a bathtub or shower. An effective solution is to use a specially designed heating film. The heating element, glued directly to the back of the mirror, raises its temperature and allows water droplets to evaporate. Mission Air heating films guarantee a clean, condensation-free mirror surface. PREPARING FOR INSTALLATION: A power supply (~230V) must be provided to the mirror's installation location. First, install a flush-mounted electrical box, which is connected to the mains power supply. The cable powering the heating film is also connected to the power source (in the electrical box). The film can be activated in two ways: with a separate switch or with a shared switch integrated with the room's lighting. Simple installation: Clean the mirror with a mirror cleaner. Avoid products that could leave greasy residue. Apply the anti-fog film to the back of the mirror. Be sure to leave a few centimeters from the edges free for the mirror adhesive. Carefully begin applying the anti-fog film to the back of the mirror. Use a soft cloth or sponge to thoroughly adhere the anti-fog film to the back of the mirror, while removing any air bubbles. Gradually pull the protective film in the direction indicated by the arrow in the drawing. You can now connect the anti-fog film electrically and mount the mirror to the wall. Note: Do not use any sharp tools during installation as they could damage the mat. The mat should not be shortened or cut. Specification: unit power − 98 W foil dimensions − 70 cm x 70 cm thickness − 0.2 mm surface − 0.49 m2 power cable length − 45 cm heating element − conductive paths substrate − reinforced polyester