XD-39 PWM To Voltage Volt Converter Module 0%-100% 0-10V

Description:

- PWM-to-voltage module can convert the digital PWM signal 0%-100% into an analog signal 0 ~ 10V.

- Can be used for industrial control panel or other signal interface switching, by adjusting the PWM duty cycle to regulate the output voltage.

- Adopts embedded microcontroller technology, easy to operate, you can fine-tune it through the potentiometer.

- Further increases the output voltage accuracy to within 1%, the input frequency is increased to 3KHZ, support PWM, duty cycle to voltage (via short resistor) and 5V/10V selection (via short resistor).

Specification:

- Size: Approx. 33.14 x 33.02 mm/1.304 x 1.3 inches

- 5/10 short D/F open 1-1KHz frequency to 0-5V (duty cycle at will)

- 5/10 open D/F open 1-1KHz frequency to 0-10V (duty cycle at will)

- 5/10 short D/F short 0-100% duty cycle to 0-5V (frequency range 1Hz-3KHz)

- 5/10 open D/F short 0-100% duty cycle to 0-10V (frequency range 1Hz-3KHz)

- Supply voltage: 9V ~ 24V

- Signal input frequency range: 1Hz ~ 3KHz (amplitude 3.3V-5V)

- Signal input duty cycle range: 0 ~ 100% (amplitude 3.3V-5V)

- Output voltage: 0.00V ~ 5.00V/0.00V ~ 10.00V

- Error Tolerance: within 1%, linear conversion

- Wiring definition:

- 12V: Positive power connector (9V to 24V)

- GND: Power ground interface

- PWM: signal input (1-1KHz 0-100%) (amplitude 3.3V-5V)

- GND: signal input negative interface or ground

- OUT: Signal output interface (0.00V to 5.00V/0.00V to 10.00V)

- GND: Ground interface

Note: When the output is from 0.00V to 10.00V, the power supply voltage must be more than 10 volts.

Package Includes: 1 Piece PWM to Voltage Converter Module